- Local Assistance Home
- DLA Sitemap
- Disadvantaged Business Enterprise
- E-76 Status
- Inactive Projects
- Local Assistance Contacts
- Other Links
- Program Information
- Reports and Databases
- Training Programs
- Update Notification
Intelligent Transportation Systems (ITS) Program
Intelligent Transportation Systems (ITS) improves transportation safety and mobility and enhances productivity through the integration of advanced communications technologies into the transportation infrastructure and in vehicles. ITS encompass a broad range of wireless and wire line communications-based information and electronics technologies.
ITS Program focus on federal-aid ITS project development procedures to assure compliance with the federal ITS regulations, per Code of Federal Regulations, Chapter 23, Section 940 (23 CFR 940) entitled “Intelligent Transportation System Architecture and Standards.” In addition, these procedures establish the roles and responsibilities for all parties who are involved in the federal-aid ITS process.
Caltrans Division of Local Assistance (DLA) issued its LPP 12-01 on 1/27/12 to address the procedure change for High-Risk (Formerly "Major") ITS Projects.
The requirements for projects in this program are subject to changes by Congress or FHWA each year. For the most current requirements, the local agency must rely on the latest annual FHWA ITS Deployment Program Guideline. The FHWA guidelines are normally issued every January and are available on the FHWA Discretionary Program web site at: http://www.fhwa.dot.gov/discretionary/
Upon FHWA approval of the project description, the project follows the federal-aid procedures in Chapter 13 "Intelligent Transportation Systems (ITS) Program," of the LAPG. This program, however, has a couple more requirements during and after construction. They are the quarterly status reports and project evaluation.
A. Instructions for ITS Program Guidelines
Instructions on Implementation of ITS program Guidelines, the Narrated PowerPoint Slideshow (updated on 01/30/2014). If you have any difficulty downloading/reviewing the slideshows, please contact Frank Cao at Frank.Cao@dot.ca.govB. Intelligent Transportation Systems (ITS) Program Guidelines
The ITS program guidelines can be downloaded here:
Option #1- Download the Entire ITS Program Guidelines.
|TOC||Table of Contents||Section 8:||Right-of-Way|
|Section 1:||Introduction||Section 9:||Procurement/Construction|
|Section 2:||Types of ITS Projects||Section 10:||Record Keeping|
|Section 3:||ITS Project Development and Funding||Section 11:||References|
|Section 4:||General ITS Responsibilities||Section 12:||Web Sites|
|Section 5:||Funding Process Step-By-Step Procedures||Section 13:||Definitions|
|Section 6:||Environmental||Exhibit A:||Process Flowchart - High-Risk (formerly Major) ITS Projects|
|Section 7:||ADA Requirements||Exhibit B:||Process Flowchart - High-Risk (formerly Minor) ITS Projects|
C. Types of ITS Projects
ITS projects are divided into three types: Exempt, Low-Risk, and High-Risk projects. The planning and development process to be followed is different for these three types. The previous version of this Guideline referred to Low-Risk projects as “Minor” ITS projects, and High-Risk projects as “Major” ITS projects. .
The following attributes can often be used to classify ITS projects as exempt, low, or high risk.
Exempt ITS projects do not require a Systems Engineering Analysis (SEA) and are not covered under these ITS Program Guidelines. All activities of the traditional roadway project development life-cycle process will be followed. No further ITS-specific action is necessary. They can be any the following:
- Upgrades to an existing traffic signal – This may include, for example, adding or revising left-turn phasing or other phasing, adding pedestrian-crossing displays.
- Installing an “isolated” traffic signal – This is a signal not connected to any type of external signal-control system, nor likely to be in the future because of its isolation.
- Traffic signal timing projects – This includes all “studies” whose purpose is to change the coordination parameters for controlling a group of signals – but with no installation of new hardware or software.
- Studies, Plans, Analyses – This includes ITS Master Plans, Deployment Plans, Technology Studies, etc. whose product is only a document, with no new hardware of software installed.
- Routine Operations – This includes operating and maintaining any ITS elements or systems – again with no new hardware or software installed.
Low-Risk (formerly “Minor”) ITS projects are often referred to as ITS infrastructure expansion. Standard Plans, Standard Specification, and Standard Special Provisions are well documented. They will have all of the following characteristics:
- Single jurisdiction; single transportation mode (highway, transit or rail)
- No software creation; commercial-off-the-shelf (COTS) or proven software
- Proven COTS hardware & communications technology
- No new interfaces
- System requirements fully detailed in writing
- Operating procedures fully detailed in writing
- Project life-cycle not shortened by technology service life
High-Risk (formerly “Major”) ITS projects are often referred to as ITS “System Developments.” They have one (or more) of the following characteristics:
- Multi-Jurisdictional or Multi-modal
- Custom software is required
- Hardware and Communications are “cutting-edge” or not in common use
- New interfaces to other systems are required
- System requirements not detailed or not fully documented
- Operating procedures not detailed or not fully documented
- Technology service life shortens project life-cycle
These risk factors are discussed in
- single transportation mode (highway, transit or rail)
more detail in Table 13-1.
D. SERF Form and other editable Forms
System Engineering Report Form (SERF), Exhibit 7-I (Word version, 2-page PDF version, and 4-page PDF version), is required for Low-Risk (formerly "Minor") and High-Risk (formerly "Major") ITS Projects. For detailed information regarding SERF, access Chapter 7 "Field Review," of Local Assistance Procedure Manual (LAPM). Samples of SERF can be found at FHWA California Division website http://www.fhwa.dot.gov/cadiv/segb/examples/delexp.htm
System Engineering Management Plan (SEMP) is required for High Risk (formerly "Major") ITS Projects. The samples of SEMP can be found at FHWA California Division website http://www.fhwa.dot.gov/cadiv/segb/examples/del.htm.
F. LAPG Orientation
G. Related Links
Caltrans home page: http://www.dot.ca.gov
FHWA California Division Office: http://www.fhwa.dot.gov/cadiv/
FHWA home page: http://www.fhwa.dot.gov
ITS Benefit-cost Database: http://www.benefitcost.its.dot.gov/
ITS System Cost Database: http://www.itscosts.its.dot.gov/
ITS Conformity Rule: http://www.its.dot.gov/aconform/aconform.htm
ITS Eligibility Costs for Operating a Transportation Management System: http://ops.fhwa.dot.gov/travelinfo/resources/ops_guide.htm
ITS Integration Program: http://www.fhwa.dot.gov/discretionary
ITS Standards: http://www.its.dot.gov
National ITS Architecture: http://www.iteris.com/itsarch/
System Engineering Guidebook for ITS: http://www.fhwa.dot.gov/cadiv/segb
NHI Its Training Courses: http://www.nhi.fhwa.dot.gov/home.aspx
UC Berkeley ITS Courses: http://www.its.berkeley.edu/techtransfer/train/opn/byDate.lasso
US DOT ITS site: http://www.its.dot.gov/
If you have any questions or are experiencing problems downloading, please contact your local Caltrans District Local Assistance Office or the Caltrans HQ Division of Local Assistance ITS Coordinator.
To report any difficulty experienced in accessing Caltrans programs, services or activities or any discriminations covered under the Americans with Disabilities Act, Section 504 of Rehabilitation Act or the Fair Employment and Housing Act, please contact us at (866)810-6346 Voice; 711 TTY; (916)653-3055 Fax.